Visor Edge Battery 14-0007-00

- High power 2CR5 Lithium Ion (Li-Mn) Batteries
- One of two common, 6volt lithium batteries in use in today's compact AF and SLR cameras. This battery is distinguished by the square contact points along the battery's top edge that drape over the side.
- Can be used for many high drain applications: Photo cameras, PDA, and many other photo equipments.
- Ultra long shelf life with minimal natural discharge.
- Ultra high energy density and last 3-5 times longer than ordinary alkaline batteries in high current drain devices like digital cameras.
- Fast Flash performance with a consistent and very short recycle time.
- Warning: Can Not Be Recharged!

Technical Specifications
- Voltage:6V
- Capacity: 1100mAH
- Dimension: Height x Diameter: 17 x 45 mm
- Weight: 0.55 Oz

Features and Benefits

• NIMH High Power 14.4V 3600mAh rechargeable battery
• Compatible with all Roomba FloorVac models.
• Longer running time - this high power, high capacity NIMH and has 10-15% more running time than OEM battery pack.
• 70 ^oC thermistor installed in the battery pack. Power will be cutt off if battery temperature beyond 70^oC during charging to prevent from over charge.
• Can be recharged up to 1000 cycles.
• 6" length wires is pre-installed for easy installation.
• For faster and safe charging, strongly suggest you use our New 12-16.8V Universal Smart charger, changing time is about 5-6 hours.
• The battery is designed for exactly replacing inside battery pack for IRobot Vacuum cleaner. e.g Roomba APS 4905 battery.
  - To replace inside battery, you need to take off 4 screws on the case, then put new battery with solid connection.
  - Please make sure polarity of battery pack. Red wire is always connect to positive
  
• TECHNICAL SPECIFICATIONS:
  - Votlage: 14.4V, made of 12 pcs High quality NiMH sub C cells. and packed by 2x6 configuration
  - Capacity: 3600mAh
  - Max. Discharging rate : 10 C at 33 A
  - Dimension: 136 mm L x 45 mm W x 45 mm H.
  - Weight: 38.5 Oz.
  
• Battery Installation Instruction:
  Step 1: Loose up all srews on the top cover of the Roomba Advanced Power System.
  Tool: You need a triangle screw driver to do so.
  Step 2: Open and remove the top cover from the power system, which may be glued.
  Tool: You may need a flat screw driver to open it carfuelly
  Step 3: Remove the old battery inside. Three are wires with metal contact connected inside. You can remove the wires by pulling up the contat or cut wires off.
  Take a note of the wire connections
  Step 4: Put new battery into the battery case and solder three wire back to metal contacts. Follow the note taken in Step 3 or the following details for re-wire:
  - Red wire : battery positive - metal contact near battery
  - Black wire: battery negative - metal contact near edge
  - White wire: temp sensore - metal contact on other side
  Step 5: Put back the cover
  Step 6: Screws on the cover